Adjusting stepper driver current on the Ender3 v2

The Ender3 v2 3D printer mainboard (silent mainboard v2.2) has four stepper drivers, that can be adjusted using a small trimpot. This can be useful in case an axes is losing steps (not moving at all, or randomly displaces at higher speeds). Or when the stepper driver overheats and shuts down for a while, resulting in large displacement even at lower printing speeds. The power of a stepper motor is regulated by the input voltage and the current. The current can be adjusted by setting the reference voltage (vRef) using the trimpot, which can be measured by placing a multimeter + side on the trimpot and the - side on the SD card reader.

On the Ender3 v2 Mainboard you will find a small set screw for each stepper driver, called a trimpot. To access the mainboard remove the bottom plate of the printer. Once removed, you are able to see the trimpots as on the images shown below. By adjusting the trimpot you reduce or increase the current, depending on the rotation. Be careful adjusting the trimpot, it may break easily. Always disconnect power before adjusting the trimpot and use a suitable screw driver. The following pictures shows the locations of the trimpots.

To increase the current rotate the trimpot clockwise by a few degrees. Steps of 10 degrees of change are probably best, until you find the sweet spot. For the ender3 v2 the following vRef are recommended:

X,Y,Z: 1.22V
E: 1.39V

Note that setting the current of the stepper driver too high, may cause overheating. This generally appears a random displacement of the print head, but is cause by the stepper shutting down for a small while, until the temperature has cooled down a bit.

Waarom ReprapWorld?
  • Zelfde werkdag verzonden!
  • 3.000+ producten in ons assortiment
  • Meer dan 45.000 tevreden klanten in meer dan 40 landen
  • Veilig betalen met diverse betalingsopties
  • Professionele technische ondersteuning (meer dan 10 jaar 3D ervaring)
45.000+ tevreden klanten

4.3 sterren op Google

Betaal veilig met

Over ReprapWorld

RepRapWorld is de nummer één webshop voor al uw reprap benodigdheden voor uw 3D printer. We hebben een grote collectie 3D-printer onderdelen, van onze beroemde elektronica lijnen tot filament van onze eigen productie. En dit alles aan een zeer scherpe prijs!


RepRapWorld B.V.
Klopperman 7
2292JE Wateringen
The Netherlands

Tel: +31 (0) 85 - 009 15 31

Copyright 2009 - 2021 | ReprapWorld B.V.